Active Voltage Clamp in Flyback Converters Operating in CCM Mode Under Wide Load Variation

Active clamp topologies of low power dissipation have become a very attractive solution in order to limit overvoltages in flyback converters. Although many suitable topologies have been introduced for the case of discontinuous conduction mode (DCM), where the duty cycle value depends on the load level, in continuous conduction mode (CCM) it is more difficult to appropriately design such topologies so as to "sense" load changes-due to the small duty cycle divergence under wide load variation. Taking for granted that in order to achieve high power-factor correction in these converters, CCM is a more attractive mode of operation, a drastic solution for this case that will manage to eliminate voltage stresses under wide load changes has become very essential. For this purpose, this paper presents an active clamp topology with small power dissipation, suitable for flyback converters operating in CCM mode. Its main idea is the use of a load-dependent current source, consisting of an auxiliary converter operating in DCM mode. Experimental results highlight the effectiveness of the proposed topology under wide load changes, establishing it as an appropriate solution in order to develop flyback converters, even at the power range of 500 W.