A notch stress intensity approach to assess the multiaxial fatigue strength of welded tube‐to‐flange joints subjected to combined loadings

ABSTRACT Full penetration T butt weld joints between a tube and its flange are considered, subjected to pure bending, pure torsion and a combination of these loading modes. The model treats the weld toe like a sharp V‐notch, in which mode I and mode III stress distributions are combined to give an equivalent notch stress intensity factor (N‐SIF) and assess the high cycle fatigue strength of the welded joints. The N‐SIF‐based approach is then extended to low/medium cycle fatigue, considering fatigue curves for pure bending and pure torsion having the same slope or, alternatively, different slopes. The expression for the equivalent N‐SIF is justified on the basis of the variation of the deviatoric strain energy in a small volume of material surrounding the weld toe. The energy is averaged in a critical volume of radius R C and given in closed form as a function of the mode I and mode III N‐SIFs. The value of R C is explicitly referred to high cycle fatigue conditions, the material being modelled as isotropic and linear elastic. R C is thought of as a material property, independent in principle of the nominal load ratio. To validate the proposal, several experimental data taken from the literature are re‐analysed. Such data were obtained by testing under pure bending, pure torsion and combined bending and torsion, welded joints made of fine‐grained Fe E 460 steel and of age‐hardened AlSi1MgMn aluminium alloy. Under high cycle fatigue conditions the critical radius R C was found to be close to 0.40 mm for welded joints made of Fe E 460 steel and close to 0.10 mm for those made of AlSi1MgMn alloy. Under low/medium cycle fatigue, the expression for energy has been modified by using directly the experimental slopes of the pure bending and pure torsion fatigue curves.