Search for a command to run...
The experimental validation of an application of weakly-ionized plasma actuators for improved aerodynamic performance of multi-element wings and wings with movable control surfaces is presented. Two spanwise arrays of plasma actuators, configured to produce a wall-jet effect, were applied on the suction surface of a two-dimensional NACA 0015 wing model, one at the leading edge and the other near the trailing edge to mimic the effects of a wing leading-edge slat and a trailing-edge flap, respectively. Flow control tests were conducted at chord Reynolds numbers, corrected for blockage, of 0.217 x 10 6 and 0.307 x 10 6 in a low-speed wind tunnel at the University of Notre Dame. The leading-edge-separation control resulted in an increase in both the maximum lift coefficient and the stall angle of attack and a lift-to-drag improvement of as much as 340%. An optimum frequency was found to exist for unsteady excitation of the leading-edge separation. Under this condition, the power to the actuator was estimated to be only 2 W. The trailing-edge actuator was found to produce the same effect as a plain trailing-edge flap. This included a uniform shift at all angles of attack of the lift coefficient and a shift toward higher lift coefficients of the drag bucket. In addition, there was a slight decrease in the minimum drag coefficient. The obvious advantages of this approach are its simplicity, as there are no moving parts, and its lack of hinge gaps, which add drag. An example of their use as ailerons for roll control produces a comparable roll moment coefficient to a sample general aviation aircraft.