5 Gb/in/sup 2/ recording demonstration with conventional AMR dual element heads and thin film disks

We have successfully demonstrated magnetic recording at an areal density of 5 Gb/in/sup 2/ and a data rate of 10 MB/s using narrow track dual element heads with conventional AMR sensors and low noise Co alloy thin film disks. In this work, the target densities of 240 K bpi/spl times/21 K tpi were achieved by a combination of narrow track and low-flying technologies. The write and read head trackwidths were reduced to submicron dimensions, with high moment pole-tips to maintain good writability. At the same time, magnetic spacing was substantially reduced by using low-flying airbearing surface designs. Finally, significant signal-to-noise improvements were attained with the development of high sensitivity AMR read heads and very low noise thin film media. Recording tests showed satisfactory writability in terms of overwrite and hard-transitions from the submicron width write heads. Readback yielded symmetrical signals close to 1 mV//spl mu/m and rolloff measurements yielded 50% densities as high as 7000 fc/mm. Track profile and microprofile measurements showed write and read trackwidths to be around 1.2 /spl mu/m and 0.7 /spl mu/m respectively, with tight side-writing and sidereading characteristics. An overall assessment of the parametric recording results suggested an areal density feasibility of around 5 Gb/in2. This projection was confirmed by error rate testing at 10 MB/s using a PRML channel with digital filter and write precompensation. At low ontrack errors of 10/sup -10/-10/sup -9/ without error correction codes, linear densities of /spl sim/240 K bpi and optimized track pitches of /spl sim/1.2 /spl mu/m were achieved, corresponding to areal densities of /spl ges/5 Gb/in/sup /2.