Effect of Silicon Nitride Ball on Adhesive Wear of Martensitic Stainless Steel Pyrowear 675 and AISI M-50 Races with Type II Ester Oil

Advanced bearing materials for future military and commercial gas turbines are required to operate at high speeds, high temperature, and higher thrust loads. At elevated operating conditions, the bearing and gear materials must be able to operate with ultrathin oil films without suffering detrimental effects of adhesive wear. The development of materials with rolling-element fatigue and corrosion resistance properties without deterioration in adhesive wear attributes is a significant challenge. To meet those performance requirements, the forerunner, martensitic stainless steel Pyrowear 675 (AMS 5930), has been in development for aerospace bearing and gear applications. This article addresses the adhesive wear performance of three variants of Pyrowear 675 with silicon nitride ball material simulating a hybrid bearing evaluated using a WAM8 machine. Baseline testing was conducted using conventional bearing steel AISI M-50. Adhesive wear testing was conducted at a temperature of 200°C and at different contact slips (15, 30, 50, and 70%) and entraining velocities (1.3 to 10.2 m/s). Posttest specimens were analyzed by scanning electron microscopy (SEM) and auger electron spectroscopy (AES). All the hybrid material pairs demonstrated very good adhesive wear performance compared to the baseline AISI M-50–AISI M-50 pair.