Statistical Analysis on Interlaminar Shear Strength of Nanosilica Addition with Woven Dharbai/Epoxy Hybrid Nanocomposites under Cryogenic Environment by Taguchi Technique

Biocomposites are becoming more popular due to their capacity to replace artificial materials at a lower cost while enhancing environmental responsibility. In contrast, biocomposites have poor mechanical and interface properties. This research is aimed at determining the interlaminar shear strength of composite materials reinforced with Dharbai fibre and nanosilicon powder. The composites were made using a hand lay-up method with the following conditions: (i) weight % of nanosilica filler, (ii) thickness of fibre mat, and (iii) cryogenic treatment period, each at three different levels, to meet the goals mentioned above. The composites were laminated using a traditional hand lay-up method, and their interlaminar shear strength was determined using the ASTM standard. According to a recent study, nanocomposites containing 4% nanoscale silicon and 300 grammes per square metre of woven Dharbai fibre showed the highest interlaminar shear strength after 15 minutes of cryogenic treatment. Fibre content increased the mechanical properties of pure epoxy in general. As the fibre and filler concentrations grew, more energy was required to break the fibre bundles between the matrix and its resin. According to the ANOVA, the cryogenic treatment was the most significant factor, contributing up to 59.58%, followed by woven Dharbai mate, contributing 22.11%, and nanosilicon at 18.30%. SEM is used to investigate the cracked composites’ fractographic examination.