Investigation of Gamma-Induced Changes to Screening Currents and AC Losses in Mono- Versus Multi-filamentary REBCO Coated Conductors Using DC and AC Magnetometry

Abstract REBCO (rare-earth barium copper oxide) coated conductor tapes are a highly attractive option for magnet materials in future tokamak fusion power plants. However, the threat of intense neutron and gamma radiation, together with AC losses during magnet coil ramping, has raised concerns around magnet coil lifetimes. Irradiation-induced changes to flux creep rate has been identified as a key performance-limiting factor in REBCO tapes at low temperatures and high fields post-irradiation with gamma rays; spontaneous flux creep contributes to hysteretic AC loss in REBCO cables under applied AC fields. Knowing that multi-filamentary tapes are under consideration for tokamaks as an AC loss mitigation, magnetic measurements and gamma irradiation experiments are presented here on striated and mono-filamentary YBCO tapes to investigate the differences in post-irradiation screening currents and AC losses. Reduction in AC losses improved magnetisation critical current density (J c ) retention after 1 MGy in the multi- relative to the mono-filamentary samples. After the 5 MGy dose, striations then made the multi-filamentary tape more susceptible to J c degradation because of the thinner individual filament width. Scanning transmission electron microscopy analysis on an analogous GdYBCO mono-filamentary tape did not indicate the introduction of nm-scale amorphisation to the active GdYBCO layer after gamma irradiation. A potential theoretical explanation for the underlying mechanism altering the flux-pinning landscape across the REBCO layer surface in gamma-irradiated tapes is discussed. This work concluded that gamma effects on screening current capability should be considered in future tokamak REBCO tape qualification studies.