Search for a command to run...
<div class="section abstract"><div class="htmlview paragraph">To meet the International Maritime Organization’s (IMO) short-term greenhouse gas (GHG) reduction targets, partial decarbonization of the existing fleet, often powered by medium-speed diesel engines, is required. One approach for reducing CO<sub>2</sub> emissions is to enrich the charge air with hydrogen to substitute diesel. However, hydrogen’s high reactivity can lead to combustion abnormalities such as backfire, pre-ignition, and knocking, thus limiting the feasible admixture rates. These challenges are particularly relevant in medium-speed diesel engines designed for high power output and efficiency at low rpm. While hydrogen fuel-share has previously been tested in small-bore engines at moderate loads, this study investigates the influence on combustion and achievable hydrogen admixture rates in a medium-speed, 4-stroke diesel engine operating with up to 30 bar net indicated mean effective pressure (net IMEP). To minimize retrofitting efforts and to preserve diesel performance, the investigations were conducted on a single-cylinder engine with representative design features of a conventional diesel engine: a high compression ratio, Miller valve timing, valve overlap, and a piston with deep valve pockets. The piston ring system is suited for heavy fuel oil (HFO) operation. Hydrogen was supplied via a port fuel injection (PFI) system. 0D/1D process simulations supplement the experimental data. Findings indicate that energetic hydrogen admixture rates of up to 43% are achievable at low loads, limited by an advancing start of combustion, and up to 15% hydrogen share at high loads, constrained by backfire. This results in an average CO<sub>2</sub> reduction of ~22% on the E2 cycle for constant-speed main propulsion engines. Due to rising NO<sub>x</sub> emissions, the results are only applicable when meeting IMO Tier II limits with selective catalytic reduction (SCR). The results demonstrate that conventional medium-speed diesel engines are suited for hydrogen fuel-share operation and that CO<sub>2</sub> reductions comparable to liquid natural gas (LNG) conversions are feasible.</div></div>
Published in: SAE technical papers on CD-ROM/SAE technical paper series
Volume 1
DOI: 10.4271/2026-01-5007